aris, open a new thread since it's a different issue and describe what you want to do with aireplay-ng, it has a bunch of different attacks. Regarding an issue, same solution applies to you too.
↧
Re: wlan0mon is on channel 2, but the AP uses channel 5
↧
airodump not capturing handshake
Hi,
I used the command
sudo airodump-ng --bssid 00:01:02:03:04:05 -c 3 wlan0mon -w 46ac
to try to capture handshake.
In 1 lucky previous occasion, I managed to capture 1 handshake on another access point.
However, subsequent attempt to capture hand...
I used the command
sudo airodump-ng --bssid 00:01:02:03:04:05 -c 3 wlan0mon -w 46ac
to try to capture handshake.
In 1 lucky previous occasion, I managed to capture 1 handshake on another access point.
However, subsequent attempt to capture hand...
↧
↧
Re: Nothing shows up even though the channels are altering.
Not only useful but can still be extended again
↧
Re: BCM4313 max TX power trick
I may be able to help if there is more detail.
↧
Re: airodump not capturing handshake
The signal on the stations is very low, so it is likely that you only received part of the handshake.
Check our handshake analysis tutorial to find out what you have: https://www.aircrack-ng.org/doku.php?id=wpa_capture
Check our handshake analysis tutorial to find out what you have: https://www.aircrack-ng.org/doku.php?id=wpa_capture
↧
↧
Re: WEP and WPA2 Access Point
It should be possible, but I'm not sure if such implementation still exist.
One that I can remember is the Cisco WPA migration: https://www.aircrack-ng.org/doku.php?id=wpa_migration_mode
One that I can remember is the Cisco WPA migration: https://www.aircrack-ng.org/doku.php?id=wpa_migration_mode
↧
Re: Issue with Realtek chipset?
Issue 1:
Virtualbox USB passthrough driver is crappy. But if you insist on using it, make sure it is set to USB 3.0. VMware's driver is more stable/reliable.
Make sure your system is up to date: apt update && apt dist-upgrade then reboot.
Airodump-ng b...
Virtualbox USB passthrough driver is crappy. But if you insist on using it, make sure it is set to USB 3.0. VMware's driver is more stable/reliable.
Make sure your system is up to date: apt update && apt dist-upgrade then reboot.
Airodump-ng b...
↧
Re: Issue with Realtek chipset?
Issue 2:
If you are 100% sure the bssid and clients are correct, use -D parameter.
If you are 100% sure the bssid and clients are correct, use -D parameter.
↧
Re: How do we launch the deauthentication attack on a specific channel?
There are 3 ways you can set the channel:
1. When using airmon-ng: "airmon-ng start wlan0 6" -> will set on channel 6. Make sure you kill network managers beforehand because they change channels and interfere with monitor mode.
2. Using iw
3. Using iwc...
1. When using airmon-ng: "airmon-ng start wlan0 6" -> will set on channel 6. Make sure you kill network managers beforehand because they change channels and interfere with monitor mode.
2. Using iw
3. Using iwc...
↧
↧
capture handshake however aircrack-ng reports errors on handshake
Hi,
I was lucky enough to capture two handshakes from the same access point.
However when I use aircrack-ng to crack the wpa2 passphrase it reports errors.
Below are the error messages with bssid and essid masked.
For the first handshake,
sudo aircrack...
I was lucky enough to capture two handshakes from the same access point.
However when I use aircrack-ng to crack the wpa2 passphrase it reports errors.
Below are the error messages with bssid and essid masked.
For the first handshake,
sudo aircrack...
↧
Re: capture handshake however aircrack-ng reports errors on handshake
Wordlist require the -w parameter. Any file without an option is considered a pcap file.
By the way, aircrack-ng doesn't need sudo
By the way, aircrack-ng doesn't need sudo
↧
var11n-300 Vonets
Hi guys,
Di you have any information about what chip is inside and is it working with Aircrack-ng?
Thanks,
M.
Di you have any information about what chip is inside and is it working with Aircrack-ng?
Thanks,
M.
↧
Re: var11n-300 Vonets
There is a tutorial in the wiki to help you determine the chipset.
↧
↧
Re: Working injection drivers for rtl8187l & RA2870
I want to know in various stories. More about the subject To be used in daily life
↧
Re: set VHT radiotap header?
Your website is a good web site. There are many useful information for us.
↧
Re: How do we launch the deauthentication attack on a specific channel?
There are 3 ways you can set the channel:
1. When using airmon-ng: "airmon-ng start wlan0 6" -> will set on channel 6. Make sure you kill network managers beforehand because they change channels and interfere with monitor mode.
2. Using iw
3. Using iwc...
1. When using airmon-ng: "airmon-ng start wlan0 6" -> will set on channel 6. Make sure you kill network managers beforehand because they change channels and interfere with monitor mode.
2. Using iw
3. Using iwc...
↧
capture handshake however aircrack-ng reports errors on handshake
Hi,
I was lucky enough to capture two handshakes from the same access point.
However when I use aircrack-ng to crack the wpa2 passphrase it reports errors.
Below are the error messages with bssid and essid masked.
For the first handshake,
sudo aircrack...
I was lucky enough to capture two handshakes from the same access point.
However when I use aircrack-ng to crack the wpa2 passphrase it reports errors.
Below are the error messages with bssid and essid masked.
For the first handshake,
sudo aircrack...
↧
↧
Buy British Passport online, Buy Fake Passport UK, Buy Novelty UK Drivers License, UK False ID cards
Number one producers of the U.K. Biometric Passport. Passports come to you looking exactly as the ones issued by the U.K.
Home Office. These passports are verifiable using the U.V light feature for authenticity and are just perfect for use. We
al...
Home Office. These passports are verifiable using the U.V light feature for authenticity and are just perfect for use. We
al...
↧
Re: How do we launch the deauthentication attack on a specific channel?
There are 3 ways you can set the channel:
1. When using airmon-ng: "airmon-ng start wlan0 6" -> will set on channel 6. Make sure you kill network managers beforehand because they change channels and interfere with monitor mode.
2. Using iw
3. Using iwc...
1. When using airmon-ng: "airmon-ng start wlan0 6" -> will set on channel 6. Make sure you kill network managers beforehand because they change channels and interfere with monitor mode.
2. Using iw
3. Using iwc...
↧
Re: Edit NewtorkManager.conf to prevent conflicts with airmon-ng (no check kill)
I Have the latest kali and i frequently upgrade all the tools yet this conflict between Network Manager and airmon-ng is still present, any suggestions ??
I
I
↧